Metz AF-1 Manuel d'utilisateur Page 64
- Page / 127
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
64
ķ
2 Dedicated flash functions
Dedicated flash functions are flash functions that have been specially adapted to
a given camera system. Depending on the type of camera, different flash func-
tions are supported.
• Flash-ready indication in camera viewfinder/camera display
• Automatic flash sync speed control
• FourThirds - System compatible
• Automatic flash / triggering control
• TTL with measuring preflash
• Automatic fill-in flash control
• Manual flash exposure correction for TTL
• 1st or 2nd curtain synchronisation (2nd curtain, SLOW2)
• FP high speed synchronisation (HSS) with TTL and M
• Automatic motor zoom control
• Automatic AF measuring beam control
• Automatic flash range indication
• Programmed flash mode
• Preflash function for reducing the red-eye effect
• Wireless TTL remote slave flash mode
• Wake-up function for the flash unit
• Firmware update via USB connector
It is impossible to describe all camera types and their individual dedicated
flash functions within the scope of these instructions. Therefore, please
refer to the flash mode description in your camera’s operating instructions
to find out which functions are supported and which ones have to be set
manually on the camera.
☞
3 Preparing the flash unit for use
3.1 Mounting the flash unit
Mounting the flash unit on the camera
Turn off the camera and flash before mounting or removing.
• Turn the knurled nut
towards the flash unit housing as far as it will go. The
locking pin in the adapter shoe is now fully retracted into the case.
• Slide the flash unit foot completely into the camera accessory shoe.
• Turn the knurled nut
towards the camera housing as far as it will go, clam-
ping the flash unit in place. If the camera does not have a locking hole, the
spring-loaded locking pin retracts into the adapter case so as not to damage
the surface.
Removing the flash unit from the camera
Turn off the camera and flash before mounting or dismounting.
• Turn the knurled nut
towards the flash unit housing as far as it will go.
• Remove the flash unit from the camera’s accessory shoe.
3.2 Power supply
Suitable batteries/rechargeable batteries
The flash unit can be operated with any of the following batteries:
• 4 NiCad batteries 1.2V, type IEC KR6 (size AA). They permit very fast recy-
cling times and are economical in use because they are rechargeable.
• 4 nickel-metal-hydride batteries 1.2V, type IEC HR6 (size AA). They have a
significantly higher capacity than NiCad batteries and are less harmful to the
environment, since they have no cadmium.
• 4 alkaline-manganese dry cell batteries 1.5V, type IEC LR6 (size AA).
Maintenance-free power source for moderate power requirements.
• 4 lithium batteries 1.5V, type IEC FR6 (size AA). Maintenance-free high-capa-
city power source with a low self-discharge rate.
☞
☞
707 47 0065.A1-48AF-1O Inh. 17.09.2007 13:58 Uhr Seite 64
- MECABLITZ 48 AF-1 digital 1
- 1 Sicherheitshinweise 3
- 2 Dedicated-Blitzfunktionen 4
- 3 Blitzgerät vorbereiten 4
- 4 LED-Anzeigen am Blitzgerät 5
- 5 Anzeigen am Display 6
- 6 Anzeigen im Kamerasucher 7
- 7 Blitzbetriebsarten („Mode“) 7
- 7.2 Manueller Blitzbetrieb 8
- 9 Sonderfunktionen („Select“) 10
- 9.5 Einstelllicht („ML“) 13
- 10 Blitztechniken 15
- 11 Blitzsynchronisation 16
- 12 Automatischer AF-Messblitz 17
- 14 Wartung und Pflege 17
- 15 Hilfe bei Störungen 18
- 16 Technische Daten 19
- 17 Sonderzubehör 20
- Batterie-Entsorgung 20
- Garantiebestimmungen 21
- Avant-propos 23
- 1 Consignes de sécurité 23
- 2 Fonctions flash dédiées 24
- 3 Préparation du flash 24
- 5 Indications sur l’écran 26
- 7.2 Mode flash manuel 28
- 9.6 Mode zoom étendu («Ex») 33
- 11 Synchronisation du flash 35
- 11.2 Synchronisation normale 36
- 14 Maintenance et entretien 37
- 17 Accessoires en option 40
- Elimination des batteries 40
- Voorwoord 43
- 1 Veiligheidsinstructies 43
- 2 Dedicated flitsfuncties 44
- 3 Flitser gereedmaken 44
- 7 Flitsfuncties (‘Mode’) 47
- 7.2 Manual flitsfunctie 48
- (FP, c.q. HSS) 48
- 9.5 Instellicht ( ‘ML’) 53
- 10 Flitstechnieken 55
- 11 Flitssynchronisatie 56
- 12 Automatische AF-meetflits 57
- 14 Onderhoud en verzorging 57
- 15 Troubleshooting 58
- 16 Technische gegevens 59
- 17 Bijzondere toebehoren 60
- Afvoeren van de batterijen 60
- Introduction 63
- 1 Safety instructions 63
- 2 Dedicated flash functions 64
- 5 Information in Display 66
- 7 Flash modes („Mode“) 67
- 7.2 Manual flash mode 68
- 9.5 Modelling light („ML“) 72
- 9.6 Extended Zoom Mode („Ex“) 73
- 10 Flash techniques 74
- 11 Flash synchronisation 75
- 14 Care and maintenance 76
- 16 Technical data 78
- 17 Optional accessories 79
- Disposal of batteries 79
- Premessa 81
- 1 Per la vostra sicurezza 81
- 2 Funzioni flash dedicate 82
- 3 Preparazione del flash 82
- 4 Indicazioni sul flash 83
- 5 Indicazioni sul display 84
- 7 Modalità flash („Mode“) 85
- 7.2 Modo flash manuale 86
- 9.5 Luce pilota („ML“) 91
- 9.6 Modo zoom esteso („Ex“) 91
- 10 Tecniche lampo 93
- 11 Sincronizzazione del lampo 93
- 11.2 Sincronizzazione normale 94
- 14 Cura e manutenzione 95
- 16 Dati tecnici 97
- 17 Accessori opzionali 98
- Smaltimento delle batterie 98
- Introducción 101
- 1 Indicaciones de seguridad 101
- 3 Preparación del flash 102
- 4 Indicadores LED en el flash 103
- 5 Indicaciones en la pantalla 104
- 7.1 Modos TTL 105
- 7.2 Modo de flash manual 106
- 9.2 Modo remoto esclavo ( ) 109
- 9.4 Desconexión automática 111
- 9.5 Luz de modelado („ML“) 111
- 10 Técnicas de destello 113
- 11 Sincronización del flash 114
- 14 Mantenimiento y cuidados 115
- 15 Ayuda en caso de problemas 116
- 16 Características técnicas 117
- 17 Accesorios especiales 118
- Eliminación de las baterías 119
Produits connexes et manuels pour Appareil photos Metz AF-1
(148 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.520 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels